Manual Software V1.1.0

6.11 Trigger settings
The touch responsiveness can be adjusted to your needs and preferences by the set‐
tings of this menu.
1. Press [UTILITY].
ð
The display shows the Utility menu.
2. Press [PAGE] repeatedly until the desired sub menu is displayed.
3. Strike the pad whose parameter you want to modify.
4. Use the arrow buttons ([<] / [>]) or the jog wheel to change the parameter
value. Please note the information in the table below.
Param‐
eter
Display Meaning Value range
SENSI‐
TIVITY
SEN XXX Volume behaviour of a pad
regardless of the actual strike
intensity. The higher the value,
the higher the volume when
playing, and vice versa.
1…16
XTALK XTK XXX If several pads are mounted on
a rack vibrations can be trans‐
mitted to other pads when
you hit a trigger and uninten‐
tionally trigger sounds. This
crosstalk can be avoided by
the appropriate setting. The
value should be set as low as
possible.
1…8
CURVE CUR XXX The trigger curve regulates the
velocity, i.e., the ratio between
the punch and volume. Use
setting ‘Curve 1’ for the most
natural ratio between punch
and volume. When using
‘Curve 2’ or ‘Curve 3’ , a strong
strike will cause a bigger
change. When using ‘Curve 4’
or ‘Curve 5’ , a light strike will
cause a bigger change. With
the setting ‘Curve 6’ the
volume changes less upon a
change of the strike. High vol‐
umes are already reached at a
relatively low strike intensity.
The gure below shows the
various options schematically.
1…6
Adjusting trigger settings
Operating
e-drum module
24