User manual

6. Next, insert the two side panels (8). Ensure that the two fixing pins latch properly at the lower border of each side panel in
the floor plate. Tilt the side panel upwards and latch the locking mechanisms on both sides.
7. Install the rear panel (9) and the rack door (10).
To do this, place the lower hinge pin in the borehole of the floor plate provided for this purpose. Pull the upper spring-
loaded hinge pin back and place the rear panel in such a manner that the pin can latch into the borehole of the cover plate
provided for this purpose. Allow the hinge pin to latch in position and check that the rear panel is fitted securely.
Place the rack door in the borehole of the floor plate provided for this purpose just as was done for the lower hinge pin. Pull
the upper spring-loaded hinge pin back and place the rack door in such a manner that the pin can latch into the borehole
of the cover plate provided for this purpose. Allow the hinge pin to latch in position and check that the rack door is fitted
securely.
Next, install the locks supplied.
Installation
IR-2012, IR-2022
9