SDS
8.2.2. Personal protection
Eye and face protection
Safety glasses with side shields
Chemical goggles.
Contact lenses may pose a special hazard; soft contact lenses may absorb and concentrate irritants.
Skin protection
Under normal conditions of use, no special skin and body protection equipment is required in addition to ordinary work clothes. When there is a possibility
of splashing, please select suitable and permeability safety clothing and safety shoes according to the actual situation in the workplace. The recommended
material is nitrile rubber.
Hands/feet protection
Use oil-resistant, chemical-resistant protective gloves. Nitrile rubber, neoprene, PVC gloves are recommended. Replace contaminated gloves promptly.
Wash thoroughly with soap and water after operation.
When there is a possibility of splashing, please select suitable and permeability safety clothing and safety shoes according to the actual situation in the
workplace. The recommended material is nitrile rubber.
Body protection See Other protection below
Other protection
Overalls.
P.V.C.
Respiratory protection
There is no need to wear respiratory protective equipment under normal conditions of use. If the engineering control facility does not maintain the concentration of oil mist at a
level sufficient to protect the health of the relevant personnel, respiratory protection equipment that meets the relevant regulatory requirements must be selected. For details,
consult your respiratory protection equipment supplier.
8.2.3. Environmental exposure controls
See section 12
SECTION 9 PHYSICAL AND CHEMICAL PROPERTIES
9.1. Information on basic physical and chemical properties
Appearance Pale yellow transparent liquid
Physical state Liquid Relative density (Water = 1) 0.8552
Odour Not Available
Partition coefficient n-octanol /
water
Not Available
Odour threshold Not Available Auto-ignition temperature (°C) Not Available
pH (as supplied) Not Available Decomposition temperature 300
Melting point / freezing point
(°C)
-24 Viscosity (cSt) 34(40℃)
Initial boiling point and boiling
range (°C)
Not Available Molecular weight (g/mol) Not Available
Flash point (°C) 231 Taste Not Available
Evaporation rate Not Available Explosive properties Not Available
Flammability Not Flammable Oxidising properties Not Available
Upper Explosive Limit (%) Not Available
Surface Tension (dyn/cm or
mN/m)
Not Available
Lower Explosive Limit (%) Not Available Volatile Component (%vol) Not Available
Vapour pressure (kPa) Not Available Gas group Not Available
Solubility in water (g/L) Not Available pH as a solution (1%) Not Available
Vapour density (Air = 1) Not Available VOC g/L Not Available
9.2. Other information
Not Available
SECTION 10 STABILITY AND REACTIVITY
10.1.Reactivity See section 7.2
10.2. Chemical stability
Unstable in the presence of incompatible materials.
Product is considered stable.
10.3. Possibility of hazardous
reactions
See section 7.2
10.4. Conditions to avoid Extreme temperatures, sun exposure, exposure to strong oxidants, ignition sources
10.5. Incompatible materials Strong oxidants
10.6. Hazardous decomposition
products
No dangerous decomposition products will form under normal storage conditions
SECTION 11 TOXICOLOGICAL INFORMATION
Version No:1.0
Page 4 of 8
Heat Transfer Fluid for Electric Heater
Issue Date:20/06/2018
Continued...