Use and Care Manual

Attach runner to inside edge of face frame.
Note the roller wheel is positioned at the
bottom with the opening up. Repeat on
opposite side.
Install roll-out tray.
Determine location desired and install
plastic “back boot” in pre-drilled holes.
Attach with screws. Repeat on opposite
side.
Slide runner into “back boot”. Repeat on
opposite side.
ROLL-OUT TRAY RELOCATION/INSTALLATION
ADJUSTING THE DOOR ALIGNMENT - WITH PHILLIPS SCREWDRIVER
Rotate front screw
for horizontal door
adjustment.
In a standard Base Cabinet there are two
locations a Roll-out Tray can be installed,
indicated by the two sets of pre-drilled holes
on the back panel.
1 2
3 4
Rotate back screw
for front to back
door adjustment.
For vertical door
adjustment loosen
center screw on
each hinge. Set
door at desired
height. Re-tighten
each screw.
HEIGHT DEPTHSIDE
TO SIDE