User Manual

ManualsBrandsMiLight ManualsEnergy SavingWi-Fi Controller MiLight HTL-026 for MiLight GR306, MiLight GR306&GR307

MiLight Wi Controller Instructions

To begin, search for the free “MiLight” app

from the Apple App Store or Android Apps on

Google Play.

Continue by plugging your

Wi Controller Hub into

a USB port or USB wall

adapter.

After a few moments, go

to your device’s settings to

connect to the “milight” Wi

network.

MiLight Wi Hub MiLight Wi Receiver

Summary of content (4 pages)

PAGE 1
MiLight Wifi Controller Instructions MiLight Wifi Hub MiLight Wifi Receiver To begin, search for the free “MiLight” app from the Apple App Store or Android Apps on Google Play. Continue by plugging your Wifi Controller Hub into a USB port or USB wall adapter. After a few moments, go to your device’s settings to connect to the “milight” Wifi network.
PAGE 2
1-2 minutes after connecting to the “milight” Wifi network, open the MiLight app and select “milight” from the device list. You can now type in a name for your MiLight Device. When you select your MiLight Device, you are presented with 6 monitors. Select the 2nd monitor to control your RGB LED Light Strips. (Android users: Your monitor is located at the bottom/left of the list.
PAGE 3
On Off + Brightness - + Animations + Speed To synchronize your MiLight Hub to your Receiver: 1: Begin with your LED’s connected to your MiLight Receiver, but disconnected from your 12V DC power source. 2: Plug the power into your MiLight Receiver, and press the Speed + Button on your screen within 5 seconds. 3: Your LED’s should flash to signal a successful pairing between the MiLight Hub and Receiver. If not, repeat steps 1 and 2.
PAGE 4
Connecting MiLight to Your Home Wifi Network: 1: Select your MiLight and then press “Configuration”. 2: In Configuration, press “Wifi Setting”. 3: Your device will scan for available Wifi Networks. Select your home network. 4: If necessary, enter the password for your home wifi network and press “OK”. 5: If your password is correct, press “OK” on the “Success” notification and wait for your app to return to the Device List. Your MiLight Wifi Hub will need to restart for 2-3 minutes.