User Manual

7
UG65 can also be powered by an 802.3af standard PoE injector or other PoE device. If both are
connected, DC power is preferred.
3.3 Antenna Installation
The antenna should be installed vertically always on a site with a good signal. If you select embedded
antenna mode, do not let the front panel of products faces to walls.
If you use 1.3m high gain antenna kit, fix the LoRa antenna to a pole via antenna clamp kit: pass the
LoRa antenna through the antenna clamp and fix it with 4 screws, then wrap the U-bolt around a pole
and fix the clamp with nuts and other accessories. After installation, connect the antenna to gateway
antenna connector via the coaxial cable.
3.4 Hotspot Installation
UG65 can be mounted to a wall or a pole. Before you start, make sure that your SIM card has been
inserted, your antennas have been attached and all cables have been installed.
3.4.1 Wall Mounting
Preparation: mounting bracket, bracket fixing screws, wall plugs, wall mounting screws and other
required tools.
A. Align the mounting bracket horizontally to the desired position on the wall, use a marker pen to mark
four mounting holes on the wall, and then remove the mounting bracket from the wall.
Note: The connecting lines of adjacent points are at right angles.
B. Drill four holes with a depth of 32 mm by using your drill with a 6 mm drill bit on the positions you
marked previously on the wall.
C. Insert four wall plugs into the holes respectively.