User Manual

23
8. Packet Forwarder Configuration
UG65 has installed multiple packet forwarders including Semtech, Chirpstack-Generic MQTT broker, etc.
A. Go to “Packet Forwarder” → “General” page and click
to add a network server.
B. Fill in the server information and enable this server. If Helium is enabled, you can enable Semtech,
Chirpstack type package forwarder or remote Embedded NS at the same time.
Note: when you add any NS or modify the NS setting and click “Save & Apply”, the Helium program will
reboot and disconnect for dozens of seconds.
C. Go to “Packet Forwarder” → “Radio” page to configure antenna type, center frequency and channels.
The channels of the gateway and network server need to be the same.