User Manual

28
via SMS
4.5 LoRa D2D Settings (LoRaWAN Version Only)
LoRa D2D protocol is developed by Milesight and used for setting up transmission among
Milesight devices without gateway. When the LoRa D2D setting is enabled, UC300 can work as a
LoRa D2D controller to send control commands to other devices or work as a LoRa D2D agent to
receive commands to trigger the DO or RS485 devices.
1. Go to “General -> Basic” page, enable LoRa D2D feature, define a unique LoRa D2D k
ey which is the same as LoRa D2D controller or agent devices. (Default LoRa D2D Key:
5572404C696E6B4C6F52613230313823)
2. Go to “LoRaWAN Settings -> Basic” to configure the RX2 datarate and RX2 frequency. When
UC300 works as LoRa D2D controller, it will send commands as RX2 settings.
3. Go to “Command” page to set corresponding operations.
When DI triggers, UC300 can work as LoRa D2D controller to send control command to control