User Guide

3. Power Button and Buzzer Patterns

4. Configuration Guide

DS3604

1. Download “Milesight ToolBox” App on an NFC-supported smartphone.

DS3604 equips with power button inside to switch on/off the device for

emergency use. Usually users can use NFC to complete all steps.

Press and hold the power button

for more than 3 seconds.

Press and hold the power button

for more than 10 seconds.

Off→Buzz Slowly

Buzz Quickly

Power On/Off

Reset to Factory

Default

Function Action Buzzer Status

1 × Warranty Card

1 × DS3604 Device 1 × 3M Double-Sided Tape

1 × Quick Start Guide

Screen Button：tap to receive downlink commands like screen content update,

device reboot, etc.

E-Ink Screen

NFC Area

Screen Button

IoT E-INK DISPLAY

FEATURING LoRaWAN

1. Packing List

2. Hardware Introduction

All Software & files can be downloaded from

https://www.milesight-iot.com/documents-download/

Cloud App Quick Start Guide

Milesight IoT Co., Ltd. www.milesight-iot.com

iOSAndroid

Building C09, Software Park Phase III, Xiamen 361024, Fujian, China

PAGE 1
Screen Button：tap to receive downlink commands like screen content update, device reboot, etc. 1. Packing List 3. Power Button and Buzzer Patterns DS3604 equips with power button inside to switch on/off the device for emergency use. Usually users can use NFC to complete all steps. DS3604 1 × DS3604 Device 1 × 3M Double-Sided Tape Function Power On/Off 1 × Quick Start Guide 1 × Warranty Card 2. Hardware Introduction Action Press and hold the power button for more than 3 seconds.
PAGE 2
. Open “Milesight ToolBox” App and attach the smartphone with NFC area to read/write the device until App shows a successful prompt. It’s suggested to configure a device password for security. (Default password: 123456) Fixed by Screws 1. Release the screw on the bottom of device and remove the back cover, mark the installing holes to the wall according to the holes on the back cover.