Installation Manual

CODE HOPPING TWO CHANNEL TRANSMITTER
The CODE HOPPING transmitter (1281): each time, it is pressed, will randomly transmit a
different code. This prevents the thieves from using a code grabber to copy the code and
re-transmitting the code to disarm the alarm system.
Two noticeable feature.
• Channel 1 -- Disarm
• Channel 2 – Arm/Panic
• L.E.D.—Indicates that the button is being
depressed.
Note : To replace the batteries in the transmitter, gently to separate top and bottom cover by
fingers, take out old batteries and replace with new one, ensure correct polarity.
Never get wet or submerge transmitter in water, as this will invalidate warranty.
Functions
Operating step
System Response
Programming of
additional remotes
*Car Alarm in power on
at least 10 seconds.
*Press Un-lock
*Power off to Power on
10 times
*Press Lock into
programming(can
programming 3 remotes
simultaneous)
* After programming all
the remotes, it will
automatically off
programming mode or
exit for 10 seconds
without operation.
• LED flash 10 times
• Siren chip 1 time
• NO1 remote-LED flash 1 time
and siren chip 1 short sound
• NO2 remote-LED flash 2 time
and siren chip 2 short sounds
• NO3 remote-LED flash 3 time
and siren chip 3 short sounds
• Siren chip 2 times
Note: Up to 3 remotes for 1 Car Alarm.