Specifications

Regulatory Information
regs.htm[3/15/2022 8:15:16 AM]
Europe:
Model AX411E2W
Software Version Intel® PROSet/Wireless WiFi Software 22.x and subsequent versions
Maximum Power Output
(2400 - 2483.5 MHz)
IEEE802.11 b/g/n/ax
mode
Bluetooth
20dBm EIRP max (100mW)
(2400 - 2483.5 MHz)
BLE
10dBm EIRP max (10mW)
(5150 - 5725 MHz)
IEEE802.11 a/n/ac/ax
mode
23dBm EIRP max (200mW)
The low band 5.15 - 5.35 GHz is for indoor use only
(5725 - 5875 MHz)
IEEE802.11 a/n/ac/ax
mode
13.98 dBm EIRP Max (25mW)
For the standard EN 300 440, the device operating in 5.8 GHz is considered a
category 2 receiver
(5925 - 6425 MHz)
IEEE802.11ax
23 dBm EIRP max (200mW)
The band 5.925 - 6.425GHz is for LPI (Low Power in-door)
This equipment complies with the essential requirements of the European Union directive 2014/53/EU.
INFORMATION FOR OEMS and HOST INTEGRATORS
The guidelines described within this document are provided to OEM integrators installing Intel® wireless adapters in notebook and
tablet PC host platforms. Adherence to these requirements is necessary to meet the conditions of compliance with FCC rules,
including RF exposure. When all antenna type and placement guidelines described herein are fulfilled the Intel® wireless adapters
may be incorporated into notebook and tablet PC host platforms with no further restrictions. If any of the guidelines described herein
are not satisfied it may be necessary for the OEM or integrator to perform additional testing and/or obtain additional approval. The
OEM or integrator is responsible to determine the required host regulatory testing and/or obtaining the required host approvals for
compliance.
Intel® wireless adapters are intended for OEMs and host integrators only.
The Intel® wireless adapter FCC Grant of Authorization describes any limited conditions of modular approval.
The Intel® wireless adapters must be operated with an access point that has been approved for the country of operation.
Changes or modification to Intel® wireless adapters by OEMs, integrators or other third parties is not permitted. Any changes or
modification to Intel® wireless adapters by OEMs, integrators or other third parties will void authorization to operate the
adapter.
Antenna Type and Gains
Only antennas of the same type and with equal or less gains as 3dBi for the 2.4GHz band and 5dBi for the 5GHz band shall be used
with the Intel® wireless adapters. Other types of antennas and/or higher gain antennas may require additional authorization for
operation. For testing purposes the following dual band antenna that approximates closely the above limits was used:
Antenna Antenna Location 2.4GHz Peak 5.2GHz Peak 5.5GHz Peak 5.7GHz Peak