Specifications

Regulatory Information
regs.htm[3/15/2022 8:15:16 AM]
信 指依電信管理法規定作業
之
無線電通信。低功率射頻器材須忍受合法通信或工業、科學及醫療用電波輻射性電機設備
之
干擾。應
避免影響
附
近雷達系統
之
操作。高增益指向性天線只得應用於固定式點對點系統。
Radio Approvals
To determine whether you are allowed to use your wireless network device in a specific country, please check to see if the radio type
number that is printed on the identification label of your device is listed in the manufacturer's OEM Regulatory Guidance document.
Modular Regulatory Certification Country Markings
A list of countries requiring regulatory markings is available. Note that the lists include only countries requiring marking but not all
certified countries. To find the regulatory country marking information for your adapter, perform these steps:
1. Open this web site: http://www.intel.com/content/www/us/en/support/network-and-i-o/wireless-networking/000007443.html
2. Click on the link for your adapter.
3. Click on Regulatory Marking Document for your adapter.
INFORMATION FOR OEMs and HOST INTEGRATORS
The guidelines described within this document are provided to OEM integrators installing Intel® wireless adapters in notebook and
tablet PC host platforms. Adherence to these requirements is necessary to meet the conditions of compliance with FCC rules,
including RF exposure. When all antenna type and placement guidelines described herein are fulfilled the Intel® wireless adapters
may be incorporated into notebook and tablet PC host platforms with no further restrictions. If any of the guidelines described herein
are not satisfied it may be necessary for the OEM or integrator to perform additional testing and/or obtain additional approval. The
OEM or integrator is responsible to determine the required host regulatory testing and/or obtaining the required host approvals for
compliance.
Intel® wireless adapters are intended for OEMs and host integrators only.
The Intel® wireless adapter FCC Grant of Authorization describes any limited conditions of modular approval.
The Intel® wireless adapters must be operated with an access point that has been approved for the country of operation.
Changes or modification to Intel® wireless adapters by OEMs, integrators or other third parties is not permitted. Any changes or
modification to Intel® wireless adapters by OEMs, integrators or other third parties will void authorization to operate the
adapter.
Antenna Type and Gains
Only antennas of the same type and with equal or less gains as 3dBi for the 2.4GHz band and 5dBi for the 5GHz band shall be used
with the Intel® wireless adapters. Other types of antennas and/or higher gain antennas may require additional authorization for
operation. For testing purposes the following dual band antenna that approximates closely the above limits was used:
Antenna
Type
Antenna Location
(Main/Aux)
2.4GHz Peak
Gain in dBi*
5.2GHz Peak
Gain in dBi*
5.5GHz Peak
Gain in dBi*
5.7GHz Peak
Gain in dBi*
PIFA Main
Aux 3.24 3.73 4.77 4.77
MIMO
*All antenna gains include cable loss.
Antenna Placement Within the Host Platform
To ensure RF exposure compliance the antenna(s) used with the Intel® wireless adapters must be installed in notebook or tablet PC
host platforms to provide a minimum separation distance from all persons, in all operating modes and orientations of the host platform,
with strict adherence to the table below. The antenna separation distance applies to both horizontal and vertical orientation of the
antenna when installed in the host system.