Owners Manual

4
Rear Panel Layout
A B E FC D
Rear Panel Layout
A. OUTPUT 1–MaleXLRconnectorforChannelOnemicrophone
input
B. OUTPUT 2–MaleXLRforChannelTwomicrophoneinput
C. IEC Socket – Connect a standard IEC power mains cable
D. VOLTAGE switch – Used to select the Mains operating voltage.
IMPORTANT NOTE: Be sure to check the switch is set to the
correct voltage used in your country.
E. INPUT 1–FemaleXLRconnectorforChannelOnemicrophone
output
F. INPUT 2–FemaleXLRconnectorforChannelTwomicrophone
output
Setting Up the MPA-201
First, decide where you want to position the MPA-201. e unit can be
mounted in a standard equipment rack, or can be set on a workstation
desktop. If you are setting up on a desk top, be sure to install the
included rubber feet.