Owners Manual

11
Installing the SM7 Shockmount
The C7e kit comes with a SM7 shockmount, which you can use to
greatly reduce any noise transmitted through the mic stand. The
shockmounts are especially useful in reducing the problems caused by
a boomy soundstage, for example when miking overhead cymbals, or
even in the studio with talent that likes to move a lot on a floor that
may not be as solid as it should be.
• TousetheC7ewithitsincludedshockmount,screwthe
shockmount on a solid mic stand. If you are using a US standard
5/8-inch mic stand, remove the Euro adapter by unscrewing it from
the shockmount.
• Oncetheshockmountismountedtothestand,lineupthebottom
threaded section of the C7e to the holder and slowly rotate the
bottom thumbscrew clockwise until it screws on hand tight. Be
careful not to cross thread the screws.
• Youcanloosenthebottomthumbscrewslightlytomakeleftand
right adjustments to the mic, and then re-tighten it once it’s in
place.
• Loosenthethumbscrewtosetthemicrophoneangleandthen
tighten once it’s in place.
Operating the C7e