User Manual

Controller user's manual INDU-50 v1.95(86)EN
| 8
www.mikster.eu
6.3. AUTOSTART mode
Press the key to edit parameters for this mode.
AUTOSTART mode can be activated in two ways:
1. At specified time (hour and minute) and daily delay, if any (F47 SETUP – HMD).
2. After counting down a specified time (hours and minutes) (F47 SETUP - HM)
Pressing START button during edit mode couses begining of waiting mode for START (AUTOSTART). To quit the AUTOSTART
mode, press the key once again. You can switch immediately from the AUTOSTART mode into the START mode by
pressing the START key.
6.4. START mode
To start and end the START mode, press key . For typical controller settings after switching into the START mode all
regulators are activated and the process time counting down is started. The time in hours and minutes to the process end is
shown on the display.
Depending on the SETUP configuration the following process end conditions may occur.
 after process time elapsing (process timeout)
 after the required bar temperature is reached
 obtaining the required pasterisation number
The process end is indicated with an internal audible signal and by closing the REL5 Output To switch audible signal off,
press. .