User Manual

Controller user's manual INDU-50 v1.95(86)EN
www.mikster.eu
| 7
6. Operation description
6.1.
EDIT mode – setpoint changing
To get into the setpoint edit mode press the EDIT key. .
When the edit mode is activated, the EDIT key flashes .
You can change parameters on the display by using the keyboard .
To confirm or move to the next field, press to exit press .
Setpoint sequence:
 START mode duration (hours: minutes)
 controller temperature setpoint based on channel 1
 controller temperature setpoint based on channel 2
6.2. INFO mode
Press the key to recal information depending on the current controller operating mode.
For the AUTOSTART mode
According to the setting in the Setup menu, item SF47:
 For HMD — hour, minute and daily delay when the START mode is to be activated
 For HM — hours and minutes to the START mode
Other information is identical for each mode:
 channel 3 measurement (Ad-3), Measurement on channel 2

; the calculated jacket temperature setpoint**
 channel 1 and channel 2 temperature setpoints
 current date
 current time
To get the next (previous) information, press
* when governor type 4 is set for channel 3
**when the pasterisation number is being counted
ATTENTION!
Channel 3 temperature setpoint can be entered in the SETUP menu (item SF38).