User's Manual

wAP R
Quick start
1. Use a Phillips screwdriver to loosen the screw which secures the bottom lid. Once the screw snaps out of
place, lid can be opened.
2. Power the unit using one of the methods described in the Powering section of this document
3. Wireless AP mode is enabled by default, you can connect from your computer to the SSID that begins with
“MikroTik”. The configuration interface is available via web browser. The address is http://192.168.88.1
4. The device is already preconfigured and ready to use, but we suggest to set a wireless password and a
device password to secure your network and protect your device.
Powering
• The ethernet port accepts 9-30V passive PoE power. The box contains a 24V adapter and a PoE injector.
Plug the included PoE injector into the first or internet port of the router that you will use in your LAN (or
directly into your laptop) and attach an ethernet cable to the PoE injector. Connect the other end of this
ethernet cable to the wAP LTE device. Plug the power supply into the PoE injector.
• Power jack (5.5mm outside and 2mm inside diameter, female, pin positive plug) supports 9-30V powering,
the device comes with a 24V 0.8A power adapter.
• The automotive connector can be used to power the device from regular 12/24V connections in
automobiles and buses.
Maximum power consumption at 24V is 4W without miniPCIe, and 7W with full load on the miniPCIe card.
Mounting
The device can be mounted in several ways: wall, ceiling or pole. The package includes a drill hole template, to
help you with the ethernet cable installation and attachment to a ceiling or a wall. The package also includes a steel
bracket to put on the other side of a dropdown ceiling tile and two screws and wall anchors.
To prepare the device for mounting, use a Philips screwdriver to remove the screw inside the unit, which will detach
the mounting plate. Once the mounting plate is removed, use the drill hole template, to help you with cable
installation and attachment to a ceiling or a wall. The template includes visual guides and instructions how to mount
the unit.
Expansion slots and ports
 Built in 2.4GHz wireless access point module, AP/station/bridge/p2p modes are supported.
 One 10/100 ethernet port, supporting automatic cross/straight cable correction (Auto MDI/X). Either straight
or crossover cable can be used for connecting to other network devices. The ethernet port accepts 9-30V DC
powering from a passive PoE injector.
 miniPCIe slot and SIM slot (can’t be used separately) to be used with a 3G/4G/LTE modem (some kits
include it).
See www.routerboard.com for more information. Contact [e-mail] for support questions. 2-Feb-17