Parts List

wAPG60adM
See www. mikrotik .com for more information. Contact [e-mail] for support questions.
Meant for profesional use only.
Federal Communication Commission interference statement
FCC ID: TV7WAPG60ADM
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of the following measures:
This device is not to be operated on aircraft except for the conditions listed on FCC CFR §15.255 (b).
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device
must accept any interference received, including interference that may cause undesired operation. This device and
its antenna must not be co-located or operation in conjunction with any other antenna or transmitter.
IMPORTANT: Exposure to Radio Frequency Radiation. 20 cm minimum distance has to be maintained between
the antenna and the occupational user and 20 cm to general public. Under such configuration, the FCC radiation
exposure limits set forth for an population/uncontrolled environment can be satisfied.
Any changes or modifications not expressly approved by the manufacturer could void the user's authority to operate
this equipment.
This module is intended for OEM integrator only and limited to host with brand: MikroTik and model:
RBwAPG-60ad-SA, RBwAPG-60ad. This module is only FCC authorized for the specific rule parts listed on the grant,
and that the host product manufacturer is responsible for compliance to any other FCC rules that apply to the host not
covered by the modular transmitter grant of certification.
The final host product still requires Part 15 Subpart B compliance testing with the modular transmitter installed.
Antenna Installation. WARNING: It is the installer's responsibility to ensure that when using the authorized
antennas in the United States (or where FCC rules apply); only those antennas certified with the product are used.
The use of any antenna other than those certified with the product is expressly forbidden in accordance to FCC
rules CFR47 part 15.204. The installer should configure the output power level of antennas, according to country
regulations and per antenna type. Professional installation is required of equipment with connectors to ensure
compliance with health and safety issues.