User's Manual

See www.routerboard.com for more information. Contact [e-mail] for support questions. 19-May-14
ButtonsandJumpers
• RouterOS reset jumper hole (no direct access, board has to be removed from case) – resets RouterOS software to
defaults. Must short circuit the metallic sides of the hole (with a screwdriver, for example) and boot the device. Hold
screwdriver in place until RouterOS configuration is cleared.
• RouterBOOT reset button (access through the door) has two functions:
o Hold this button during boot time until LED light starts flashing,
release the button to reset RouterOS configuration (same result as with reset hole)
o Hold this button during boot time longer, until LED turns off,
then release it to make the device look for Netinstall servers.
OperatingSystemSupport
CurrentlytestedoperatingsystemisMikroTikRouterOS(startingfromversion6.13).
CopyrightandWarrantyinformation
CopyrightMikroTiklsSIA.Thisdocumentcontainsinformationprotectedbycopyrightlaw.Nopartofitmaybereproducedor
transmittedinanyformwithoutpriorwrittenpermissionfromthecopyrightholder.RouterBOARD,RouterOS,RouterBOOT
andMikroTikaretrademarksofMikroTiklsSIA.Alltrademarksandregisteredtrademarksappearinginthisdocumentarethe
propertyoftheirrespectiveholders.
Hardware.MikroTikwarrantsallRouterBOARDseriesequipmentforthetermoftwelve(12)monthsfromtheshippingdate
tobefreeofdefectsinmaterialsandworkmanshipundernormaluseandservice,exceptincaseofdamagecausedby
mechanical,electricalorotheraccidentalorintendeddamagescausedbyimproperuseorduetowind,rain,fireorotheracts
ofnature.
ToreturnfailedunitstoMikroTik,youmustperformthefollowingRMA(ReturnMerchandiseAuthorization)procedure.
Followtheinstructionsbelowtosavetime,efforts,avoidcosts,andimprovethespeedoftheRMAprocess.
1. IfyouhavepurchasedyourproductfromaMikroTikReseller,pleasecontacttheResellercompanyregardingall
warrantyandrepairissues,thefollowinginstructionsapplyONLYifyoupurchasedyourequipmentdirectlyfromMikroTik
inLatvia.
2. MikroTikdoesnotofferrepairsforproductsthatarenotcoveredbywarranty.Exceptionscanbemadefor:
CCR1016-12G,CCR1016-12G-BU,CCR1036-12G-4S,RB1100,RB1100AH,RB1100AHx2,RB1200,RB600,RB600AandRB800
asapaidservice(feesapply).
3. Out-of-warrantydevicesanddevicesnotcoveredbywarrantysenttoMikrotikwillbereturnedtothesenderat
sender'scost.Ifthecustomerhasnotorganizedreturnofsuchrejecteddeviceswithin12monthsfromthedayofarrival,
MikroTikhastherighttodiscardthem.
RMAInstructionsarelocatedonourwebpagehere:http://rma.mikrotik.com
Thisdocumentisprovided“asis”withoutawarrantyofanykind,expressedorimplied,including,butnotlimitedto,the
impliedwarrantyofmerchantabilityandfitnessforaparticularpurpose.Themanufacturerhasmadeeveryefforttoensure
theaccuracyofthecontentsofthisdocument,however,itispossiblethatitmaycontaintechnicalinaccuracies,
typographicalorothererrors.Noliabilityisassumedforanyinaccuracyfoundinthispublication,norfordirectorindirect,
incidental,consequentialorotherdamagesthatmayresultfromsuchaninaccuracy,including,butnotlimitedto,lossofdata
orprofits.Pleasereportanyinaccuraciesfoundto[e-mail]
 