Owner's Manual

Federal Communication Commission Interference Statement
(FCC ID: TV7RB411AR)
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one of the following measures:
● Reorient or relocate the receiving antenna.
● Increase the separation between the equipment and receiver.
● Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
● Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This device and its antenna must not be co-located or operation in conjunction with any other
antenna or transmitter.
IMPORTANT: Exposure to Radio Frequency Radiation.
20 cm minimum distance has to be maintained between the antenna and the occupational user
and 45 cm to general public. Under such configuration, the FCC radiation exposure limits set
forth for an population/uncontrolled environment can be satisfied.
List of approved antennas. Installer shall be responsible for ensuring that the proper antenna
is employed so that the limits in FCC Part 15 are not exceeded.
2.4GHz 20.5dBi Panel Antenna AT-20PN-24
2.4GHz 24dBi Die Cast Aluminum Grid Antenna, DC24HDPF1P-EZ
2.4GHz 15dBi Omni Antenna VP, AT-15OM-24
2.4GHz 13dBi Omni Antenna HP, ODH24-13
2.4GHz 17dBi 90deg Sector Vertical Polarization SA24-90-17-WB