Assembly Instructions

OEM statement. This module is intended for OEM installations only. As such the OEM
integrator is responsible for ensuring that the end-user has no manual instructions to remove install
or modify the module. This module is limited to installations in mobile or fixed applications. OEM
integrators may utilize antennas of like an equal or lesser gain as appearing in the list in this
document (reference 47 CFR, paragraph 15.204(c)(4) for further information on this topic. The
MikroTik OEM RF Module complies with Part 15 of the FCC rules and regulations.
The Grantee will provide guidance to the Host Manufacturer in ensuring compliance with the Part 15
Subpart B requirements.
OEM Modules have been certified by the FCC for use with other products without any further
certification (as per FCC section 2.1091). Separate approval is required for other operating
configurations including portable configurations with respect to 47CFR paragraph 2.1093 and
different antenna configurations. The OEM is required to comply with all 47CFR labeling instructions
and requirements for the finished products.
Changes or modifications not expressly approved by MikroTik could void the OEM authority to install
or operate the equipment. OEMs must test their final product to comply with unintentional radiators
(FCC section 15.107 and 15.109) before declaring compliance of their final product to Part 15 of the
FCC Rules.
WARNING: the OEM must ensure that the FCC labeling requirements are met. This includes a
clearly visible label on the outside of the OEM enclosure specifying the appropriate MikroTik OEM RF
Module FCC identifier for this product as well as any other required FCC notices as presented below.
Contains FCC ID: TV7R11E5HM
This enclosed device complies with 47CFR paragraph 15 C of the FCC rules and regulations.
Operation is subject to the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received, including interference
that may cause undesired operation.
Labeling and text information should be of a size of type large enough to be readily legible,
consistent with the dimensions of the equipment and the label.
WARNING: This device has been tested with a MMCX connector and antennas as listed in the table
below. When integrated into the OEM products, these fixed antennas require professional
installation. Preventing end users from replacing them with non-compliant antennas.
List of approved antennas for 5GHz:
• Omni Directional, MT-482016/N/A, 9 dBi;
Antennas of same type and lower gain than those listed above may be used in compliance with
certification.
See www.routerboard.com for more information. Contact [e-mail] 29-Jan-19