User's Manual

FCC Caution: Any changes or modifications not expressly approved by the party responsible
for compliance could void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must
accept any interference received, including interference that may cause undesired operation.
This device and its antenna must not be co-located or operation in conjunction with any other
antenna or transmitter.
Warning: This device has been tested with a MMCX connector and antennas as listed in the
table below. When integrated into the OEM products, these fixed antennas require professional
installation preventing end users from replacing them with non-compliant antennas.
List of approved antennas:
 Omni Directional, MT-482016NA, 8.5 dBi
 Panel Antenna, PA58-24-ANT, 24 dBi
 Dish Antenna, HDDA5W-32-DP2, 32 dBi
Antennas of same type and lower gain than those listed above may be used in compliance with
47CFR paragraph 15.212. Additional certification will be required for use other than fixed or
mobile installation.
Antenna Installation warning: It is installer's responsibility to ensure that only those
antennas certified with the product are used for operation in the United States (or where FCC
rules apply). The use of any antenna other than those certified with the product is expressly
forbidden in accordance to FCC rules CFR47 paragraph 15.204. It is the installers’
responsibility to configure the output power level according to country regulations and antenna
type.