User's Manual

FCC Caution: Any changes or modifications not expressly approved by the party responsible

for compliance could void the user’s authority to operate this equipment.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) This device may not cause harmful interference, and (2) this device must

accept any interference received, including interference that may cause undesired operation.

This device and its antenna must not be co-located or operation in conjunction with any other

antenna or transmitter.

Warning: This device has been tested with a MMCX connector and antennas as listed in the

table above. When integrated into the OEM products, these fixed antennas require professional

installation preventing end users from replacing them with non-compliant antennas.

List of approved antennas:

 Omni Directional, WLO-2450-15, 15 dBi;

 Omni Directional HP, ODH 24-13, 13dBi;

 Panel, WLP-2450-20, 20 dBi;

 Sector, SA-24-90-17-WB, 17 dBi;

 Dish, DC 24-HD-PFIP, 24 dBi;

Antennas of same type and lower gain than those listed above may be used in compliance with

certification.

Antenna Installation

Warning: It is installer's responsibility to ensure that only those antennas certified with the

product are used for operation in the United States (or where FCC rules apply). The use of any

antenna other than those certified with the product is expressly forbidden in accordance to FCC

rules CFR47 paragraph 15.204. It is the installers’ responsibility to configure the output power

level according to country regulations and antenna type. Professional installation is required of

equipment with connectors to ensure compliance with health and safety issues.

Antenna

Model

Gain

(dBi)

Maximum Transmit Power

Per Chain

Total (dBm)

Omni Directional

WLO-2450-15

Omni Directional HP

ODH 24-13

Panel

WLP-2450-20

Sector

SA 24-90-17-WB

Dish

DC 24-HD-PFIP