Assembly instructions

B C D

F G H KJ LI

*The preview is valid if Sleeve is installed to mANT30 PA and equipped with MikroTik RB900 series outdoor device (both are sold separately).

Sleeve assembly preview back* Sleeve assembly preview front*

mANT series Sleeve

Quick setup guide and warranty information

Package contents

Front Cover

x 1 pc

Sleeve Part #1

x 1 pc

Sleeve Part #2

x 1 pc

Sleeve Part #3

x 1 pc

M6 Bolt

x 24 pcs

M6 Fender Washer

x 48 pcs

M6 Spring

Lock Washer

x 24 pcs

M6 Nut

x 24 pcs

M4 Bolt

x 6 pcs

M4 Sealing Washer

x 12 pcs

M4 Nut

x 6 pc

Silicone Sealant

x 1 pc

MikroTik Antenna assembly preview

PAGE 1
mANT series Sleeve Quick setup guide and warranty information Package contents A B Front Cover x 1 pc E M6 Bolt x 24 pcs C Sleeve Part #1 x 1 pc F M6 Fender Washer x 48 pcs G M6 Spring Lock Washer x 24 pcs Sleeve Part #2 x 1 pc H M6 Nut x 24 pcs D I M4 Bolt x 6 pcs Sleeve Part #3 x 1 pc J M4 Sealing Washer x 12 pcs K M4 Nut x 6 pc L Silicone Sealant x 1 pc MikroTik Antenna assembly preview Sleeve assembly preview back* Sleeve assembly preview front* *The preview is valid if Sleeve
PAGE 2
Installation Guide 0. Items Required • 7mm Wrench • 10mm Wrench • PH2 Screw Driver • • This guide is written to be used with mANT30 series antenna device • SLEEVE PART #1 - B SLEEVE PART #2 - C 1. Set Up Sleeve Parts Arrange Sleeve Parts as shown in Figure 1 using: [B] Sleeve Part #1 x 1 pc; [C] Sleeve Part #2 x 1 pc; [D] Sleeve Part #3 x 1 pc. Important: • Make sure the part contact areas are clean; • Drainage bores on Sleeve Part #3 [D] indicates bottom. SLEEVE PART #3 - D FIG. 1 2.
PAGE 3
4. Install Front Cover Install the Front Cover [A] - see Figure 4. Use following fasteners: [E] M6x16 Bolt x 12 pcs; [F] M6 Fender Washer x 24 pcs; [G] M6 Spring Lock Washer x 12 pcs; [H] M6 Nut x 12 pcs. E F Important: • Adjust the Front Cover [A] alignment cut at the bottom. Alignment cut must match drainage bores; • Do not tighten the fasteners firmly until all have been fitted; • M6 fastener tightening torque must be approximately 7 Nm. A F G H D FIG. 4 5.