User Manual

Locate the internal antenna cable and replace it with the SMA cable connector on the LR card.
Reassembly.
Buttons and jumpers
The reset button has three functions:
Hold this button during boot time until LED light starts flashing, release the button to reset RouterOS configuration (total 5 seconds).
Keep holding for 5 more seconds, LED turns solid, release now to turn on CAP mode. The device will now look for a CAPsMAN server (total 10
seconds).
Or Keep holding the button for 5 more seconds until LED turns off, then release it to make the RouterBOARD look for Netinstall servers (total 15
seconds).
Regardless of the above option used, the system will load the backup RouterBOOT loader if the button is pressed before power is applied to the device.
Useful for RouterBOOT debugging and recovery.
Accessories
The package includes the following accessories that come with the device:
EU/US Switching Power Supply 24 V , 0.8 A, 19.2 W, 85.3 %, VI, cable:150 cm Hor CMC.
WAP desk bracket.
WAP outdoor case bracket AL, white.
POE Injector cable.
Cable (H4130-04PDB000R 3 mm 2x2P Housing) to (StripJacket 5 cm+WireEnd Strip/Tin 1 cm) 24 AWG.
Hose Clamp, 35-70 mm, W4.
K-52 fastening set.
WAP-drill-template, paper brochure.
Operating system support