Quick Guide

Expansion Slots and Ports
 Built in wireless access point module, AP/station/bridge/p2p modes supported
 One 10/100 or 10/100/1000 Gigabit Ethernet port (depends on model), supporting automatic cross/straight
cable correction (Auto MDI/X), so you can use either straight or crossover cable for connecting to other
network devices. The Ethernet port accepts 12-57V DC powering from a passive PoE injector or 802.3af/at
source.
Buttons and Jumpers
The reset button has the following functions:
 Hold this button during boot time until LED light starts flashing, release the button to reset RouterOS
configuration (total 5 seconds).
 Keep holding for 5 more seconds, LED turns solid, release now to turn on CAP mode. The device will now
look for a CAPsMAN server (total 10 seconds).
 Or Keep holding the button for 5 more seconds until until LED turns off, then release it to make the
RouterBOARD look for Netinstall servers (total 15 seconds).
Regardless of the above option used, the system will load the backup RouterBOOT loader if the button is pressed
before power is applied to the device. Useful for RouterBOOT debugging and recovery.
Operating System Support
The device supports RouterOS software with the version number at or above what is indicated in the RouterOS
menu /system resource. Other operating systems have not been tested.
See mikrotik.com for more information. Document #40850. Modified on 05/31/18