User Manual

1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
Once logged in, we recommend clicking the "Check for updates" button in the QuickSet menu, as updating your RouterOS software to the latest version
ensures the best performance and stability. For wireless models, please make sure you have selected the country where the device will be used, to
conform with local regulations.
RouterOS includes many configuration options in addition to what is described in this document. We suggest starting here to get yourself accustomed to
the possibilities: . In case IP connection is not available, the Winbox tool ( ) can be used to connect to the MAC address https://mt.lv/help https://mt.lv/winbox
of the device from the LAN side (all access is blocked from the Internet port by default).
For recovery purposes, it is possible to boot the device from the network, see a section .SXT R#Reset button
MiniPCIe slot usage
This SXT version is without a factory modem installed. In order to install the module, you will need to remove the plastic top and withdraw the PCB plate
from the bottom case. Installing a miniPCIe module should be done by a qualified person, please follow safety precautions when handling electrical
equipment:
Use a wrist grounding strap when unpacking and working with electrical components to avoid electrical discharge (ESD) damage.
Removing the top cover, insert plastic tool in one of the six holes, turn slightly to the side and twitch carefully to slightly release the cover from
holding into the place.
Continue to work around until all of the clamps are released.
Remove the top cover by lifting it up.
You will access the upper side of PCB and antenna, remove two black soft pads to access PCB holders.
Push both plastic holders to opposite sides to release the PCB board from its position.
Remove the PCB board, carefully lift it up and place it on the anti-static mat.
Locate the mini PCIe slot on the bottom of the PCB and remove two factory attached screws.
Attach provided a thick thermal pad to the card.
Install the card into a miniPCIe slot so that the thermal pad is between PCB and card.
The secure card in place using previously removed two screws.
Attach the grey uFL connector to the MAIN antenna connector of the modem, attach the black cable to the secondary (or AUX) connector. Use
silicone type rubber to secure wiring in place.
Attach a thinner thermal pad to the top of the card.
Reassembly in backorder.
After you have reinserted the device into the case, slide in the SIM cards from your mobile operator into the SIM slots, with the chips facing down.