User Manual

designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment
does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to
try to correct the interference by one of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device and its
antenna must not be co-located or operation in conjunction with any other antenna or transmitter.
IMPORTANT: Exposure to Radio Frequency Radiation.
This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and
operated with a minimum distance of 40 cm between the radiator and any part of your body.
Industry Canada
IC: LHG 2 - 7442A-LHG2ND
LHG 5 - 7442A-LHG5NDM
LHG 5 ac - 7442A-LHG5ACD
LHG HP5 - 7442A-LHG5HPND
This device complies with Industry Canada's license-exempt RSS standard(s). Operation is subject to the following two conditions: (1) this device may not
cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux
conditions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi,
même si le brouillage est susceptible d'en compromettre le fonctionnement.
IMPORTANT: Exposure to Radio Frequency Radiation.
This equipment complies with the IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated
with a minimum distance of 40 cm between the radiator and any part of your body.
Cet équipement est conforme aux limites d'exposition au rayonnement IC définies pour un environnement non contrôlé. Cet équipement doit être installé et
utilisé à une distance minimale de 40 cm entre le radiateur et toute partie de votre corps.
CAN ICES-3 (B)/NMB-3(B)
(EN) EU Responsible Party Details: / (DE) Angaben zur verantwortlichen Partei der EU: /
(FR) Détails de la partie responsable de l'UE: / (IT) Dettagli della parte responsabile dell'UE:/
(ES) Detalles de la parte responsable de la UE:
(EN)Company name:
(DE) Name der Firma:
(FR) Nom de la compagnie:
(IT) Nome della ditta:
(ES) Nombre de empresa:
(RU) Название компании:
(EN) Address:
(DE) Adresse:
(FR) Adresse:
(IT) Indirizzo:
(ES) Habla a:
(RU) Адрес:
(EN) Contact:
(DE) Kontakt:
(FR) Contacter:
(IT) Contatto:
(ES) Contacto:
(RU) Контакт:
Email: (EN) Phone No.:
DE) Telefonnummer.:
(FR) Pas de téléphone.:
(IT) Telefono:
(ES) Telefono no.:
(RU) Номер телефона.:
SIA “Mikrotīkls” Brivibas gatve 214i, Riga, LV1039, Latvia MikroTik Compliance Department [e-mail] [phone]