Quick Guide

Federal Communication Commission Interference Statement
FCC ID: TV7GROOVE-5HN, TV7GROOVE-2HN, TV7GRV-A52HPN. This equipment has been tested and found to
comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could
void the user’s authority to operate this equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This device and its antenna must not be co-located or operation in conjunction with any other antenna or
transmitter.
IMPORTANT: Exposure to Radio Frequency Radiation. This equipment complies with the FCC RF radiation
exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a
minimum distance of 20cm between the radiator and any part of your body.
Antenna Installation. WARNING: It is installer's responsibility to ensure that when using the authorized antennas in
the United States (or where FCC rules apply); only those antennas certified with the product are used. The use of
any antenna other than those certified with the product is expressly forbidden in accordance to FCC rules CFR47
part 15.204. The installer should configure the output power level of antennas, according to country regulations and
per antenna type. Professional installation is required of equipment with connectors to ensure compliance with
health and safety issues.
LIST OF APPROVED 2GHz ANTENNAS:
• 24 dBi Dish DC 24-HD-PFIP
• 20 dBi Panel WLP-2450-20
• 17 dBi Sector SA 24-90-17-WB
• 15 dBi Omni Directional (pole) WL0-2450-15
• 13 dBi Omni Directional (hor. Polarization) HP, 0DH 24-13
LIST OF APPROVED 5GHz ANTENNAS:
• 8.5 dBi Omni MTI Wireless MT-482016NA
• 24 dBi Panel Pacific Wireless PA58-24
• 32 dBi Dish Pacific Wireless HDDA5W-32-DP
Antennas of same type and lower gain than those listed above may be used in compliance with certification.
See www.mikrotik.com for more information or contact [e-mail] Document #42039. Modified on 18-Jul-18