User Manual

ManualsBrandsMikroTik ManualsComputers & AccessorieshEX PoE

Table Of Contents

hEX PoE

hEX PoE

hEX PoE is a powerful five-port Gigabit Ethernet router with an SFP port capable of powering other devices.

First use

Choose your powering solution, please see the section for possibilities.Powering

Connect your Internet cable to port 1 (labeled "Internet"), and local network computers to ports 2-5.

Connect your direct input power jack if not using POE, to start up the device.

If using POE please see section on how to connect.POE Adapter

The device will boot up and after the short beep, the network will be available for connecting.

Set your computer IP configuration to automatic (DHCP).

Once connected to the network, open in your web browser to start configuration, since there is no password by default, you https://192.168.88.1

will be logged in automatically.

We recommend clicking the "Check for updates" button and updating your RouterOS software to the latest version to ensure the best

performance and stability.

Set up your password on the screen that loads.

Mounting

Summary of content (5 pages)

PAGE 1
hEX PoE hEX PoE hEX PoE is a powerful five-port Gigabit Ethernet router with an SFP port capable of powering other devices. First use 1. 2. 3. 4. 5. 6. Choose your powering solution, please see the Powering section for possibilities. Connect your Internet cable to port 1 (labeled "Internet"), and local network computers to ports 2-5. Connect your direct input power jack if not using POE, to start up the device. If using POE please see section POE Adapter on how to connect.
PAGE 2
This device is designed for use indoors by placing it on the flat surface or mounting on the wall, mounting points are shown in the picture below, screws are not included in the package. Screws with size 4x25 mm fit nicely, depending on your wall structure you can use dowels 6x30 mm and 6 mm drill bit if needed. When mounting on the wall, please ensure that the cable feed is pointing downwards. We recommend using Cat6 cable for our devices. The IP rating scale for this device is IPX0.
PAGE 3
Please visit wiki pages for MikroTik SFP module compatibility table: https://wiki.mikrotik.com/wiki/MikroTik_SFP_module_compatibility_table Buttons and jumpers Reset button The RouterBOOT reset button has the following functions. Press the button and apply the power, then: Release the button when green LED starts flashing, to reset RouterOS configuration to defaults. Release the button when the LED turns solid green to clear all configuration and bridge all interfaces.
PAGE 4
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation.
PAGE 5
HR Mikrotīkls SIA ovime izjavljuje da je radijska oprema tipa RouterBOARD u skladu s Direktivom 2014/30/EU. Cjeloviti tekst EU izjave o sukladnosti dostupan je na sljedećoj internetskoj adresi: https://mikrotik.com/products HU Mikrotīkls SIA igazolja, hogy a RouterBOARD típusú rádióberendezés megfelel a 2014/30/EU irányelvnek. Az EU-megfelelőségi nyilatkozat teljes szövege elérhető a következő internetes címen: https://mikrotik.