User Manual

1.
2.
1.
2.
3.
The device can be mounted using provided DIN rail mount set. Designed to fit standard 35 mm x 7.5 mm DIN rails. Attach it with two provided
screws to the device and attach the device to the DIN rail. The DIN rail is not provided in the package.
Alternatively, it is possible to attach the device to a wall, using the provided screw holes on the back of the unit. The device should be mounted in
a way that the cable openings are pointing downward as shown in the picture.
Powering
Direct-input power jack (5.5 mm outside and 2 mm inside, female, pin positive plug) accepts 12-57 V DC.
microUSB port accepts 5 V powering.
Ethernet port accepts 802.3af/at Power over Ethernet 12-57 V DC.
The power consumption under maximum load with attachments can reach 18 W (for KNOT LR8 kit and KNOT LR9 kit under maximum load with
attachments can rich 20 W).
Connecting to a PoE Adapter:
Connect the Ethernet cable from the device to the PoE+DATA port of the PoE adapter.
Connect an Ethernet cable from your local network (LAN) to the PoE adapter.
Connect the power cord to the adapter, and then plug the power cord into a power outlet.
Extension slots and ports
2.4 GHz, 802.11b/g/n, antenna gain 1.5 dBi.
Built-in GPS module (GPS, GLONASS, BeiDou, Galileo).
Two 10/100 Ethernet ports, supporting automatic cross/straight cable correction (Auto MDI/X). Either straight or crossover cable can be used for
connecting to other network devices. The Ethernet port accepts 12-57 V DC power from an PoE injector.802.3af/at
One microUSB 2.0 port for powering (for KNOT LR8 and KNOT LR9 kits only the port can be also used for peripherals).
One nano SIM slot.
Warning! This equipment should be installed and operated with a minimum distance of 20 cm between the device and your body. The operation
of this equipment in the residential environment could cause radio interference.
Mounting and configuration of this device should be done by a qualified person.