AWS Getting Started Guide

© 2021, Amazon Web Services, Inc. or its affiliates. All rights reserved.
1. The device can be mounted using provided DIN rail mount set. Designed to fit standard
35 mm x 7.5 mm DIN rails. Attach it with two provided screws to the device and attach
the device to the DIN rail. The DIN rail is not provided in the package.
2. Alternatively, it is possible to attach the device to a wall, using the provided screw holes
on the back of the unit. The device should be mounted in a way that the cable openings
are pointing downward as shown in the picture.
Warning! This equipment should be installed and operated with a minimum distance of 20 cm
between the device and your body. The operation of this equipment in the residential
environment could cause radio interference.
Mounting and configuration of this device should be done by a qualified person.
Powering:
• Direct-input power jack (5.5 mm outside and 2 mm inside, female, pin positive plug)
accepts 12-57 V DC.
• microUSB port accepts 5 V powering.
• Ethernet port accepts 802.3af/at Power over Ethernet 12-57 V DC.
The power consumption under maximum load with attachments can reach 18 W.
Connecting to a PoE Adapter:
1. Connect the Ethernet cable from the device to the PoE+DATA port of the PoE adapter.
2. Connect an Ethernet cable from your local network (LAN) to the PoE adapter.
3. Connect the power cord to the adapter, and then plug the power cord into a power outlet.