User Manual

2.
3.
4.
5.
6.
1.
2.
3.
Install and open application.
By default, the IP address and user name will be already entered.
Click Connect to establish a connection to your device through a wireless network.
Choose Quick setup and application will guide you through all basic configuration settings in a couple of easy steps.
An advanced menu is available to fully configure all necessary settings.
Powering
The device accepts power from the PoE to the Ethernet port:
Passive Power over Ethernet 8-30 V DC .
The power consumption under maximum load can reach 11,5 W.
Connecting to a POE Adapter:
Connect the Ethernet cable from the device to the POE+DATA port of the POE adapter.
Connect an Ethernet cable from your local network (LAN) to the POE adapter.
Connect the power cord to the adapter, and then plug the power cord into a power outlet.
Configuration
We recommend clicking the "Check for updates" button and updating your RouterOS software to the latest version to ensure the best performance and
stability. RouterOS includes many configuration options in addition to what is described in this document. We suggest starting here to get yourself
accustomed to the possibilities: . In case IP connection is not available, the Winbox tool ( ) can be used to connect to https://mt.lv/help https://mt.lv/winbox
the MAC address of the device from the LAN side (all access is blocked from the internet port by default). For recovery purposes, it is possible to boot the
device from a network, see the section Reset button.
Extension slots and ports
Gigabit Ethernet port, passive PoE on Ethernet port.
5 GHz wireless, supported protocol 802.11a/n/ac, antenna gain 24 (dBi).
Opening latch
To access the Ethernet port and reset button, please open latch:
Pull the latch out downwards from the device.
Lift the latch, but do not remove them completely.