Quick Guide

Buttons and jumpers
RouterBOOT reset button. This button has the following functions:
• To use the reset button, hold it and then turn on the device, while still holding the button.
• Release the button when green LED starts flashing, to reset RouterOS configuration. To not load backup
bootloader, you can start holding the button after power is already applied.
• Release the button after LED is no longer flashing (~20 seconds) to cause device to look for Netinstall
servers (required for reinstalling RouterOS over network). You can also release the button at the time,
when the device has appeared in the Netinstall utility device list.
Regardless of the above option used, the system will load the backup RouterBOOT loader if the button is pressed
before power is applied to the device. Useful for RouterBOOT debugging and recovery.
Operating system support
The device only supports RouterOS software with the version number at or above what is indicated in the
RouterOS menu /system resource. Other operating systems have not been tested.
See www. mikrotik .com for more information. Contact [e-mail] for support questions. Document #39209. Modified on 03/27/18