User Manual

ManualsBrandsMikroTik Manuals60 GHz productsWireless Wire nRAY

Table Of Contents

nRAY series

nRAY series

Wireless Wire nRAY (nRAYG-60adpair)

Safety Warnings

Before you work on any equipment, be aware of the hazards involved with electrical circuitry, and be familiar with standard practices for preventing

accidents.

Ultimate disposal of this product should be handled according to all national laws and regulations.

The Installation of the equipment must comply with local and national electrical codes.

This unit is intended to be mounted on a pole. Please read the wall mounting instructions carefully before beginning installation. Failure to use the correct

hardware or to follow the correct procedures could result in a hazardous situation to people and damage to the system.

Read the installation instructions before connecting the system to the power source.

It is the customer's responsibility to follow local country regulations, including operation within legal frequency channels, output power, cabling

requirements, and Dynamic Frequency Selection (DFS) requirements. All Mikrotik radio devices must be professionally installed.

Quickstart

Please follow these quick steps to set up your device:

Unscrew the cover to reach the Ethernet port;

Guide Ethernet cable through the opening;

Plug into the Ethernet port and screw clockwise tightly, to ensure water protection;

Connect the PoE injector into the computer;

Connect the power adapter to the PoE injector;

Download WinBox configuration tool , or use Web browser;https://mt.lv/winbox

Default IP: 192.168.88.2 and 192.168.88.3, user name: and please find the password on the sticker;

admin,

By default devices are configured as W60G Bridge;

Once connected, configure the device, so it has an active Internet connection , or proceed to the next step to upgrade https://mt.lv/configuration

software manually;

Upgrade the RouterOS software to the latest version ;https://mt.lv/upgrade

Connect again and choose your Region, this can be done in the Wireless menu W60G tab;

Double click on the W60G interface, go to the Wireless tab and choose your Region;

Powering

The device accepts power 802.3af/at PoE in 12 – 57 V DC .

The power consumption under maximum load can reach 6 W.

Connecting to a PoE Adapter:

Connect the Ethernet cable from the device to the PoE+DATA port of the PoE adapter.

Connect an Ethernet cable from your local network (LAN) to the PoE adapter.

Connect the power cord to the adapter, and then plug the power cord into a power outlet.

Mounting

Summary of content (9 pages)

PAGE 1
nRAY series Wireless Wire nRAY (nRAYG-60adpair) Safety Warnings Before you work on any equipment, be aware of the hazards involved with electrical circuitry, and be familiar with standard practices for preventing accidents. Ultimate disposal of this product should be handled according to all national laws and regulations. The Installation of the equipment must comply with local and national electrical codes. This unit is intended to be mounted on a pole.
PAGE 2
The device is designed to be used outdoors and mounted on the pole. When mounting, please ensure that the drain hole is pointing downwards. The IP rating scale of this device is IP54. We recommend using Cat6 shielded cables. Warning! This equipment should be installed and operated with a minimum distance of 60 cm between the device and your body. The operation of this equipment in the residential environment could cause radio interference.
PAGE 3
4. Attach the assembly to the pole. 5. Add mount bracket and use two 13 mm nuts to secure the device. Aim tool usage The device has led arrows on the back of the unit. Aim using the to reach precise alignment.
PAGE 4
The arrows will light up and show the direction where to turn the unit. The goal is to reach the 0.4 - 0.8 degree range, where the signal is at its peak. Grounding The installation infrastructure (towers and masts), must be properly grounded. Please secure all loose Ethernet cables and antenna cables to the pole or mast approximately 30cm from the device, so that the cable weight is not pulling the ports and connectors.
PAGE 5
IT LV LT PT RO SK LU MT NL PL SI ES UK SE CE Declaration of Conformity Manufacturer: Mikrotikls SIA, Brivibas gatve 214i Riga, Latvia, LV1039. BG С настоящото Mikrotīkls SIA декларира, че този тип радиосъоръжение RouterBOARD е в съответствие с Директива 2014/53/ЕС. Цялостният текст на ЕС декларацията за съответствие може да се намери на следния интернет адрес: https://mikrotik.
PAGE 6
IT Il fabbricante, Mikrotīkls SIA , dichiara che il tipo di apparecchiatura radio RouterBOARD è conforme alla direttiva 2014/53/UE. Il testo completo della dichiarazione di conformità UE è disponibile al seguente indirizzo Internet: https://mikrotik.com/products IS Hér með lýsir Mikrotīkls SIA því yfir að RouterBOARD er í samræmi við grunnkröfur og aðrar kröfur, sem gerðar eru í tilskipun 2014/53/EU. Fullur texti ESB samræmisyfirlýsingar er að finna á eftirfarandi veffangi: https://mikrotik.
PAGE 7
This equipment complies with EU radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with minimum distance of 20 cm between the radiator and your body, unless specifically stated otherwise in page 1 of this document. In RouterOS you must specify your country, to make sure local wireless regulations are observed.
PAGE 8
PT. Manual de instruções: Conecte o adaptador de alimentação para ligar o aparelho. Abra 192.168.88.1 em um navegador da web para configurar o produto. Mais informações em {+}https://mt.lv/help-pt+ RO. Instruciuni de utilizare: Conectai adaptorul de alimentare pentru a porni aparatul. Deschide 192.168.88.1 într-un browser web pentru a configura produsul. Mai multe informaii în {+}https://mt.lv/help-ro+ SK. Navodila: Priključite napajalnik za vklop naprave. Odprite 192.168.88.
PAGE 9
IMPORTANT: Exposure to Radio Frequency Radiation. This equipment complies with the IC radiation exposure limits set forth for an uncontrolled environment. This equipment should be installed and operated with a minimum distance of 60 cm between the radiator and any part of your body. Cet equipement est conforme aux limites d'exposition au rayonnement IC definies pour un environnement non controle.