Slant instructions

FIG. 5
FIG. 6.2
FIG. 6.1
5. Reassemble antenna components
Reverse guide steps #3 and #2
Install Back Plate to Parabolic Dish using:
M6x20 Bolt x 8 pcs;
M6 Washer x 8 pcs;
M6 Spring Lock Washer x 8 pcs;
M6 Nut x 8 pcs.
Attach Case Holder - MikroTIK Radio assembly to Back Plate by tting
Case Holder’s hinges into the Back Plate’s ange - see Figure 5.
Secure Case Holder using:
M4 Wing Nut x 1 pc.
6. Install RF cables
RF cable install instruction is shown in Figure 6.1
Connect +45° polarization to CH1, -45° polarization to CH0.
Invert the channel polarization on paired device:
Connect +45° polarization to CH0, -45° polarization to CH1.
Fit back the MikroTIK Radio cover.
Important:
• RF Cables connector tightening torque must be approximately 0.5 Nm.
Polarization slant complete