Quick Guide

Installation Guide
0. Items Required
• 10mm Wrench • 13mm Wrench • PH2 Screw Driver •
• This guide is written to be used with a MikroTik RB900 series outdoor
device (sold separately) •
1. Install Back Plate to Parabolic Dish
Install Back Plate [D] to Parabolic Dish [A] using:
[J] M6x20 Bolt x 4 pcs;
[P] M6 Washer x 4 pcs;
[O] M6 Spring Lock Washer x 4 pcs;
[N] M6 Nut x 4 pcs.
Important:
• Back Plate [D] must be aligned respecvely to a bore in the
Parabolic Dish [A] - see Fig. 1;
• M6 Nut [N] ghtening torque must be approximately 5 Nm.
2. Install Antenna Feed
Install Antenna Feed [B] to Parabolic Dish [A] using:
[C] Feed Bracket x 1 pc;
[K] M4x12 Bolt x 4 pcs;
[M] M4 Serrated Washer x 4 pcs.
Install grounding fasteners:
[L] M6 Wing Nut x 1 pc;
[M] M4 Serrated Washer x 1 pc.
Important:
• Antenna Feed [B] and Feed Bracket [C] must be aligned respecvely
to the alignment bore in the Parabolic Dish [A] - see Fig. 2;
• M4x12 Bolt [N] ghtening torque must be approximately 2 Nm.
3. Install Pole Clamp
Install Pole Clamp [E] to Back Plate [D] - see Fig. 3, using:
[J] M6x20 Bolt x 1 pc;
[P] M6 Washer x 1 pc;
[O] M6 Spring Lock Washer x 1 pc;
[N] M6 Nut x 1 pc.
Important:
• Do not ghten M6 Nut [N] firmly unl step 7.
FIG. 1
N
O
P
A
D
J
FIG. 2
L
C BMK
FIG. 3
J E
O N
D P
D
FIG. 4.2FIG. 4.1
M3x8F
L
4. Aach MikroTik Radio to Back Plate
Aach a MikroTik RB900 series outdoor device to Case Holder [F] using:
[-] M3x8 Bolt x 4 pcs (Comes with MikroTik Radio) - see Fig. 4.1.
Aach Case Holder [F] to Back Plate [D] by fing Case Holder’s hinges
into the Back Plate’s flange - see Fig. 4.2. Secure Case Holder using:
[L] M4 Wing Nut x 1 pc.
Important:
• M3x8 Bolt [-] ghtening torque must be approximately 1.5 Nm.