Quick Guide

ManualsBrandsMikroTik ManualsAntennasmANT30

KJ L

O Q R

P S

Parabolic Dish

Antenna Feed

Feed Bracket

Back Plate

Pole Clamp

Case Holder

RF Cable

Self-Bonding Tape Slice

M8 U-Bolt

M6x20 Bolt

M4x12 Bolt

M4 Wing Nut

M4 Serrated Washer

M6 Nut

M6 Spring Lock Washer

M6 Washer

M8 Nut

M8 Spring Lock Washer

M8 Fender Washer

ITEM DESCRIPTION QTY

MikroTik Antenna assembly preview

MikroTik Antenna assembly preview back* MikroTik Antenna assembly preview front

B C D

F G H I

MikroTik Antenna D-5G-30D3

Quick setup guide and warranty information

Package contents

MikroTik Radio

*The preview is valid if a MikroTik RB900 series outdoor device

(sold separately) is installed.

Summary of content (4 pages)

PAGE 1
MikroTik Antenna D-5G-30D3 Quick setup guide and warranty information Package contents ITEM A B F E J K C G L M D H N A B C D E F G H I J K L M N O P Q R S DESCRIPTION Parabolic Dish Antenna Feed Feed Bracket Back Plate Pole Clamp Case Holder RF Cable Self-Bonding Tape Slice M8 U-Bolt M6x20 Bolt M4x12 Bolt M4 Wing Nut M4 Serrated Washer M6 Nut M6 Spring Lock Washer M6 Washer M8 Nut M8 Spring Lock Washer M8 Fender Washer I O P Q R S MikroTik Antenna assembly preview MikroTik Radio Mi
PAGE 2
Installation Guide 0. Items Required • 10mm Wrench • 13mm Wrench • PH2 Screw Driver • • This guide is written to be used with a MikroTik RB900 series outdoor device (sold separately) • 1. Install Back Plate to Parabolic Dish Install Back Plate [D] to Parabolic Dish [A] using: [J] M6x20 Bolt x 4 pcs; [P] M6 Washer x 4 pcs; [O] M6 Spring Lock Washer x 4 pcs; [N] M6 Nut x 4 pcs. J N O P A D Important: • Back Plate [D] must be aligned respectively to a bore in the Parabolic Dish [A] - see Fig.
PAGE 3
5. Install RF Cables H G Remove the cover from MikroTik Radio and install the RF Cables [G]. Connect vertical polarization (arrow V) to CH0, horizontal polarization (arrow H) to CH1 - see Fig. 5. H V Insulate the RF Cable [G] ends which are connected to Antenna Feed [B] by using: [H] Self-Bonding Tape Slice x 2pcs. • Remove the plastic liner from both sides; • Stretch the tape to 2/3 of its width; • Apply half-lapped layers clockwise.
PAGE 4
Copyright and Warranty information Copyright MikroTikls SIA. This document contains information protected by copyright law. No part of it may be reproduced or transmitted in any form without prior written permission from the copyright holder. RouterBOARD, RouterOS, RouterBOOT and MikroTik are trademarks of MikroTikls SIA. All trademarks and registered trademarks appearing in this document are the property of their respective holders. Hardware.