Quick Guide

GPEN11
This device allows powering a PoE capable device over the Ethernet,
using the same voltage, as provided with the DC input jack.
Powering
The device accepts power from direct-input power jack (5.5 mm
outside and 2 mm inside, female, pin positive plug) 12-57 V DC⎓.
Power output
The device supports PoE out from Ethernet port located under the
cover. You can power Mikrotik devices which supports passive powering
through Ethernet.
Mounting
Step 1:
1. Remove the cover screw using PH2 screwdriver;
2. Remove cover to access mounting points.
Step 2:
1. Drill holes using drill bid;
2. Insert dovels if needed;
3. Attach the unit to the wall, using wall and secure with screws.
Step 1. Step 2.
See mikrotik.com/products for the latest version of this document. Page 1, Document #46507 Modified on: 29.OCT.2019