User manual
Robotics experiment with PIC microcontroller l 13
PROGRAMMER
• Read Device – Reads the program memory, data EEPROM memory, ID loca-
tions, and Configuration bits.
• Write Device – Writes the program memory, data EEPROM memory, ID loca-
tions, and Configuration bits.
• Verify – Verifies the program memory, data EEPROM memory, ID locations and Con-
figuration bits read from the target MCU against the code stored in the programming software.
• Erase – Performs a bulk erase of the target MCU. OSCCAL and band gap val-
ues are preserved (PIC12F629/675 and PIC16F630/676 only).
• Blank Check – Performs a blank check of program memory, data EEPROM
memory, ID locations and Configuration bits.
• Verify on Write - Verifies program memory, data EEPROM memory, ID locations
and Configuration bits read from the target MCU against the code stored in the pro-
gramming software with word per word.
• Full Erase (OSCCAL and BG erased) – Performs a bulk erase including the OSCCAL
and Band Gap (BG) values (PIC12F629/675 and PIC16F630/676 only).
• Regenerate OSCCAL – Regenerates the OSCCAL value (only for PIC12F629/
675 and PIC16F630/676). The AUX line must be connected to the RA4/T1G pin.
• Set Band Gap Calibration Value – Sets the band gap value.
• Write on PICkit Button - Set for supporting of programming the target microcon-
troller witth PROGRAM switch on the USB programmer board.
TOOLS
• Enable Code Protect – Enables code protection for Flash program memory.
• Enable Data Protect – Enables code protection for EEPROM data memory.
• Set OSCCAL - Sets the OSCCAL value for alignment internal clock frequency.
• Target VDD Source – Power target from the USB Programmer.
Auto-Detect : Select to USB programmer turn on or off the supply voltage
to target microcontroller automatically (not suggess to use this option).
Forced PICkit2 : Set the programmer to supply the suitable voltage to tar-
get microcontroller. After select, LED at Targer position will light and at VDD PICkit2 box
on screen will check atr On position. User can adjust the supply voltage from selection
box in the right-hand (not suggess to use this option).
Forced Target : Select to inform the software knows about the target has
voltage applied. Suggess to use this option for safty operation. Also in this option, user
must apply the supply voltage to the target PIC microcontroller.