Datasheet

5. Connecting with
a target device
For connection with a target device mikroProg™ uses female
IDC10 connector, Figure 5-1. In order to make proper connection
with the target board it is necessary to pay attention to IDC10
connector pinout. Every pin has a dierent purpose and for easy
orientation IDC10 connector is marked with a little knob and
incision, Figure 5- 2.
Front side of IDC10 connector is marked with a knob and incision.
Front side holds PGC, PGD and MCLR pins which are used for
microcontroller programming.
Figure 5-1: IDC10
connector
Figure 5-2: Knob
and incision for easy
orientation
First pin
Page 12