Datasheet

© 2009 Microchip Technology Inc. DS39775C-page 299
PIC18F87J50 FAMILY
TABLE 20-9: REGISTERS ASSOCIATED WITH SYNCHRONOUS SLAVE TRANSMISSION
20.4.2 EUSART SYNCHRONOUS SLAVE
RECEPTION
The operation of the Synchronous Master and Slave
modes is identical, except in the case of Sleep, or any
Idle mode and bit, SREN, which is a “don’t care” in
Slave mode.
If receive is enabled by setting the CREN bit prior to
entering Sleep or any Idle mode, then a word may be
received while in this low-power mode. Once the word
is received, the RSR register will transfer the data to the
RCREGx register. If the RCxIE enable bit is set, the
interrupt generated will wake the chip from the
low-power mode. If the global interrupt is enabled, the
program will branch to the interrupt vector.
To set up a Synchronous Slave Reception:
1. Enable the synchronous master serial port by
setting bits, SYNC and SPEN, and clearing bit,
CSRC.
2. If interrupts are desired, set enable bit, RCxIE.
3. If 9-bit reception is desired, set bit, RX9.
4. To enable reception, set enable bit, CREN.
5. Flag bit, RCxIF, will be set when reception is
complete. An interrupt will be generated if
enable bit, RCxIE, was set.
6. Read the RCSTAx register to get the 9th bit (if
enabled) and determine if any error occurred
during reception.
7. Read the 8-bit received data by reading the
RCREGx register.
8. If any error occurred, clear the error by clearing
bit, CREN.
9. If using interrupts, ensure that the GIE and PEIE
bits in the INTCON register (INTCON<7:6>) are
set.
Name Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
Reset
Values
on Page:
INTCON GIE/GIEH PEIE/GIEL
TMR0IE INT0IE RBIE TMR0IF INT0IF RBIF 61
PIR1
PMPIF ADIF RC1IF TX1IF SSP1IF CCP1IF TMR2IF TMR1IF 64
PIE1 PMPIE ADIE RC1IE TX1IE SSP1IE CCP1IE TMR2IE TMR1IE 64
IPR1 PMPIP ADIP RC1IP TX1IP SSP1IP CCP1IP TMR2IP TMR1IP 64
PIR3
SSP2IF BCL2IF RC2IF TX2IF TMR4IF CCP5IF CCP4IF CCP3IF 64
PIE3 SSP2IE BCL2IE RC2IE TX2IE TMR4IE CCP5IE CCP4IE CCP3IE 64
IPR3 SSP2IP BCL2IP RC2IP TX2IP TMR4IP CCP5IP CCP4IP CCP3IP 64
RCSTAx SPEN RX9 SREN CREN
ADDEN FERR OERR RX9D 63
TXREGx EUSARTx Transmit Register 63
TXSTAx CSRC TX9 TXEN SYNC SENDB BRGH TRMT TX9D 63
BAUDCONx
ABDOVF RCIDL DTRXP SCKP BRG16 — WUE ABDEN 65
SPBRGHx EUSARTx Baud Rate Generator Register High Byte 65
SPBRGx EUSARTx Baud Rate Generator Register Low Byte 65
Legend: — = unimplemented, read as ‘0’. Shaded cells are not used for synchronous slave transmission.