Datasheet

supported MCUs

page 10

EasyPIC PRO

1 2 3

How to properly place your MCU card into the socket?

Before you plug the microcontroller card into

the socket, make sure that the power supply is

turned o. Images below show how to correctly

plug the card. First make sure that MCU card

orientation matches the silkscreen outline on the

EasyPIC PRO

™

v7 board MCU socket. Place the MCU

card over the socket, so each male header encloses

the right angle with the female socket, as shown

in Figure 4-2. Then put the MCU card slowly down

until all the pins match the socket. Check again if

everything is placed correctly and press the MCU

card until it is completely plugged into the socket

as shown in Figure 4-3. If done correctly, all pins

should be fully inserted. Only now you can turn on

the power supply.

Figure 4-2: On-board

MCU socket has silksreen

markings which will help

you to correctly orient the

MCU card before inserting.

Figure 4-3: Place the

MCU card on the socket

so the pins are aligned

correctly.

Figure 4-4 Properly

placed MCU card will

have equally leveled

pins.