Datasheet

Page 12

Page 13

You can program the microcontroller with bootloader which is pre

programmed into the device by default. To transfer .HEX le from

a PC to MCU you need bootloader software (mikroBootloader

USB HID) which can be downloaded from:

After software is downloaded unzip it to desired location and

start mikroBootloader USB HID software.

http://www.mikroe.com/eng/downloads/get/1752/

mikrobootloader_lm3s9b95_v200.zip

Programming with mikroBootloader

Figure 3-2: USB HID mikroBootloader window

step 1 – Connecting mikromedia

To start, connect the USB cable, or if already connected

press the Reset button on your mikromedia board. Click the

”Connect” button within 5s to enter the bootloader mode,

otherwise existing microcontroller program will execute.