Datasheet
5. SHT1x click Board Schematics
8. Support
MikroElektronika oers Free Tech Support
(www.mikroe.com/esupport) until the
end of product lifetime, so if something goes
wrong, we are ready and willing to help!
7. Code Examples
.com
Once you have done all the necessary
preparations, it’s time to get your click
board up and running. We have provided
the examples for mikroC, mikroBasic and
mikroPascal compilers on our Libstock
website. Just download them and you are
ready to start.
6. Power supply selection
On-board PWR SEL
zero-ohm resistor (SMD
jumper) is used to
determine whether 5V
or 3.3V power supply is
used. This resistor is provided in 3.3V position
by default. In order to use SHT1x click with
5V development system, it is necessary to
resolder this jumper to 5V position.
VCC
VCC
1
2
3
4 5
6
7
8
HTS1
SHT11
AN
RST
CS
SCK
MOSI
MISO
+3.3V
GND
PWM
INT
RX
TX
SCL
SDA
+5V
GND
1
2
3
J1
VCC
+5V+3V3
R3
2K2
VCC
PWR
GND
SDA
SCL
VCC
SDA
SCL
SDA
SCL
R1
4K7
R2
4K7
C1
100nF
MikroElektronika assumes no responsibility or liability for any errors or inaccuracies that may appear in the present document.
Specication and information contained in the present schematic are subject to change at any time without notice. Copyright © 2012 MikroElektronika. All rights reserved.