Datasheet
8. Support
MikroElektronika oers Free Tech Support
(www.mikroe.com/esupport) until the
end of product lifetime, so if something goes
wrong, we are ready and willing to help!
7. Code Examples
.com
Once you have done all the necessary
preparations, it’s time to get your click
board up and running. We have provided
the examples for mikroC, mikroBasic and
mikroPascal compilers on our Libstock
website. Just download them and you are
ready to start.
6. Power supply selection
On-board PWR SEL zero-
ohm resistor (SMD jumper)
is used to determine
whether 5V or 3.3V power
supply is used. This resistor
is provided in 5V position by default. In order
to use BUZZ click with 3.3V development
system, it is necessary to resolder this jumper
to +3.3V position.
5. Buzz click Board Schematics
P1
AN
RST
CS
SCK
MOSI
MISO
+3.3V
GND
PWM
INT
RX
TX
SCL
SDA
+5V
GND
1
2
3
J1
VCC
+5V+3V3
P0
P1
P0
BUZZER
1
2
J3
1
2
J2
R2
1K
R1
10K
Q1
BC846
VCC
BUZZER
E1
10uF
R3
2K2
VCC VCC
PWR
PZ1
BUZZER
MikroElektronika assumes no responsibility or liability for any errors or inaccuracies that may appear in the present document.
Specication and information contained in the present schematic are subject to change at any time without notice. Copyright © 2012 MikroElektronika. All rights reserved.