Datasheet
Page 6
Page 7
Once we have selected the destination
project folder, let’s do the rest of the project
settings:
Step 1 - Project Settings
Figure 3-4: Enter project name and change device clock speed if necessary
01
02
03
03
01
02
Enter the name of your project. Since
we are going to blink some LEDs,
it’s appropriate to call the project
“LedBlinking”
For this demonstration, we will use
the default 16MHz clock. Clock speed
depends on your target hardware, and
whether you are using PLL or not. But
however you congure your hardware,
make sure to specify the exact clock
(Fosc) that the microcontroller is
operating at.
Click the OK button to proceed.