ic schemat VCC CN2 1 2 3 4 GND 5 VCC 6 RJ12 mikroProg to ICD2 & ICD3 Adapter board which allows you to connect mikroProg™ programmer and In-Circuit debugger to target board where only ICD2/3 connector is available for programming.
VCC PGC PGD MCLR# GND VCC CN1 1 3 5 2 4 6 7 9 8 10 M2X5 PGC PGD MCLR# CN2 1 2 3 GND 4 VCC 5 6 RJ12 HW REW. 1.00 Copyright 2003-2011 by MikroElektronika. All rights reserved. MikroElektronika assumes no responsibility or liability for any errors or inaccuracies that may appear in the present document. Specification and information contained in the present schematic are subject to change at any time without notice.
