User Manual
Page 23
8. Integrating with the casing
Ready for PIC
®
can easily be integrated into the specialized white plastic casing. This feature is very convenient for turning the board into
a nal product. The white plastic casing contains inner and outer screw holes. Inner are used for xing the board to the casing and outer
are used for xing the top part of the casing. Casing comes with holes for USB and power adapter connector, but you can customize it by
drilling and cutting holes in specic areas, depending on the target application.
Figure 8-1:
Place the board into the bottom part of
the casing. Make sure that the connectors
are aligned with square openings
Figure 8-2:
Wind screws into inner screw holes
to x the board with the bottom
plastic casing
Figure 8-3:
Place cover casing plastic and wind
screws into outer screw holes to x it
with bottom plastics casing