Datasheet

Page 18
6. Programming with mikroProg
™
programmer
Figure 6-2:
The mikroProg can be also attached on the
front side of the board. In this case, solder
1x5 header to front side pads (CN3).
Figure 6-1:
The mikroProg can be attached on the back
side of the board. Just solder 1x5 header to
back side pads (CN3) before connecting it.
The microcontroller can be programmed with the external mikroProg
™
programmer which can be connected to the board via CN3
connector. Before establishing this connection it is necessary to solder 1x5 male header to CN3 connection pads. This can be done in
both ways: on the bottom, or the top side, as shown in Figures 6-1 and 6-2.
If bootloader program is accidently erased you can upload it again through mikroProg programmer.
Program Bootloader18F87K22.hex can be found under Firmware folder (page 12).
note